1998 Chevrolet Tahoe Keyless Entry Remote Key Fob Programming Instructions

Call 888-934-0219 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.
Description

Follow these free keyless entry remote key fob programming instructions for 1998 Chevrolet Tahoe.

1.   Locate the Data Link Port. It is located under dash drivers side. Be sure you know

     which pins are 8 and 4.

   

(Note port is wider at top) Your OBDII port will not have numbers, use this diagram for reference.

2.      Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a suitable jumper wire (leave the jumper wire connected throughout the programming procedure). Make sure you know which terminals are 8 and 4. The vehicle will respond by locking and unlocking the doors to signify entering of programming mode. 

3.      Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. After about 15 seconds, the vehicle will respond by locking and unlocking the doors. Release the buttons on the transmitter.

4.      Within one minute, repeat the previous step on the remaining transmitters to be programmed.

5.    Remove jumper wire applied to th OBDII Port.

If you need an Automotive Locksmith to program this remote or for any other Automotive Locksmith needs please call Toll Free 855-899-6729 to find one in your area.

      Disclaimer 

Call 844-842-7357 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.