1998 Pontiac Grand Am Keyless Entry Remote Fob Smart Key Programming Instructions

Call 888-934-0219 if you need a Locksmith to cut or program this remote or you can go to LocateALocksmith.com to find one in your area.
Description

1998 Pontiac Grand Am Keyless Entry Remote Fob Smart Key Programming Instructions 

1. Make sure ignition is in the OFF position.
 

2. Locate the programming connector in the trunk (drivers side). It is a plastic connector with two wires leading up to it. The connector is not plugged into anything. You may have to pull back trim to access connector.

3. The programming connector should have two terminals. Connect both terminals with a suitable jumper wire. Make sure the terminals remain connected throughout the programming procedure.

4. Press the LOCK and UNLOCK buttons on the remote simultaneously. In response  the Keyless Entry Module will cycle all the Door Lock Motors at once. Your new  remote has been accepted and all existing remotes have been erased.

5. Repeat the previous step for each additional remotes (including any existing remotes) Do not remove jumper wire in between programming of remotes.

6. Remove the jumper wire from the Keyless Remote Connector.



Call 844-842-7357 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.