1999 Chevrolet Cavalier Keyless Entry Remote Key Fob Programming Instructions

Description

Follow these free keyless entry remote key fob programming instructions for 1999 Chevrolet Cavalier.

1.     
Make sure ignition is in the OFF position.
   

2.      Locate the Programming Connector in the trunk (driver’s side). It is a plastic connector with two wires leading up to it. The connector is not plugged into anything. You may have to pull back trim to access the connector.    

3.      The programming connector should have two terminals. Connect both terminals with a suitable jumper wire. Make sure the terminals remain connected throughout the programming procedure.    

4.      Press the LOCK and UNLOCK buttons on the transmitter simultaneously. In response, the Keyless Entry Module will cycle all the Door Lock Motors at once. Your new remote has been accepted and all existing remote codes have been erased.    

5.      Repeat the previous step for each additional transmitter (including any existing transmitters). Do not remove jumper wire in between programming of transmitters.    

6.   Remove the jumper wire from the Keyless Programming Connector. 


Call 855-530-0617 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.
 
 
 
 
 
Need car remotes? Replace for less at CarandTruckRemotes.com