2000 Chevrolet Malibu Keyless Entry Remote Key Fob Programming Instructions

Call 888-934-0219 if you need a Locksmith to cut or program this remote or you can go to LocateALocksmith.com to find one in your area.
Description

Follow these free keyless entry remote key fob programming instructions for 2000 Chevrolet Malibu

1.    
Close the vehicle doors.

2.   Turn ignition to the ON position then OFF.

3.   Remove key from the ignition.

4.   Press and hold the driver side door lock switch in the UNLOCK position until step 8.

5.   Insert the ignition key into the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder)

6.   Insert the ignition key into the ignition lock cylinder and remove the key.  (Do not turn the ignition key in the lock cylinder)

7.   Insert the ignition key into the ignition lock cylinder. (Do not turn the ignition key in the lock cylinder) Leave key in the ignition cylinder.

8.   Release the door lock switch. The vehicle will sound three beeps in order to verify the Program Mode has been activated.

9.   Press the LOCK and UNLOCK buttons together on the keyless remote and hold unitl the vehicle beeps twice to verify that the keyless remote has been successfully programmed. This may take approximately 15 seconds.

10.  Perform the previous step (9) to program up to four keyless remotesm, including any old ones.

11.  Remove the ignition key to exit Program Mode.



   Can I Program an ignition key for this vehicle?
      Click Here ProgramAutoKeys.com 


Call 844-842-7357 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.