2000 Mitsubishi Diamante

Call 888-934-0219 if you need a Locksmith to cut or program this remote or you can go to LocateALocksmith.com to find one in your area.


       1.  Locate the Data Port.


       2.  Insert keys in ignition and leave in the OFF position.


       3.  Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port with a suitable jumper
            wire, leave jumper wire connected  through out the programming procedure. Make sure you know which
            terminals are 1 and 4.


       4.  Within 10 seconds after connecting the jumper wire, turn the ignition switch to the ACC position and then back to
            OFF (do this as quick as you can). Repeat this procedure two more times (very quickly-you should be able to get
            the 3 ACC to OFF cycles in less than 2 seconds). Note: The doors will automatically lock and unlock once at this
            time indicating that the system is in the programming mode.


       5.  Press the LOCK  button on the remote to be registered three times within 10 seconds.  Upon successful
             programming, the doors will lock and unlock once.


       6.  If there are two remotes, register the first, then register  the second by repeating step 5 within one minute. After
            completing the second programming, the doors will lock and unlock once.


        7.  Disconnect the programming wire and remove the keys from the ignition.







Call 844-842-7357 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.