2007 Chevrolet Silverado

    2007 Old Body Style

1. Close all vehicle doors.

2. Insert the key into the ignition.

3. Hold down the power UNLOCK button on the driver’s door panel continue to hold down until instructed to release in step 9.

4. Perform steps 5 through 8 in fairly rapid succession.

5. Turn the ignition switch to the ON position (as far as you can go without starting the engine).

6. Turn the ignition switch to the OFF position.

7. Turn the ignition switch to the ON position.

8. Turn the ignition switch to the OFF position.

9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.

10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the door locks and unlocks. This step may take up to 30 seconds.

11. Repeat step 10 NOW for each additional transmitter (including any existing transmitters).

12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode.

 
Need an Auto Warranty for your vehicle? This warranty covers vehicles that are up to 15 years old and mileage up to 150,000. Call Toll Free 855-955-2396 for more information.
 
       Disclaimer

   Can I Program an ignition key for this vehicle?
      Click Here ProgramAutoKeys.com 

               
    2007 New Body Style

Use this Procedure for Vehicles with Driver Information Center Buttons

This information is in your Owners Manual in the Drivers Information Center Section.

1. Insert Key and turn to ON position so you can access Driver Information Center

2. Press the vehicle information button until  PRESS TO RELEARN REMOTE KEY displays 

3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE  displays

4.  Press and hold the lock and unlock buttons on the keyless remote at the same time for approximatley 15 seconds. A chime will sound indicating that the remote is programmed.


5.  To program additional remotes at this time repeat step 4. This vehicle can have a maximum of eight remotes programmed

6.  To exit programming mode turn key off and remove key. Test remote(s).



Use this Procedure for Vehicles without Drivers Information Center Buttons

To access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking engine)

1.  Press the trip odometer reset stem until RELEARN REMOTE KEY displays. 

2.  Press and hold the trip odometer reset stem for three seconds. The message  REMOTE KEY LEARNING ACTIVE  will display 

3.  Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.

4.  To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed.

5.  To exit programming mode turn key off and remove key. Test remote(s).

     Disclaimer

   Can I Program an ignition key for this vehicle?
      Click Here ProgramAutoKeys.com