2008 Chevrolet TrailBlazer Keyless Entry Remote Key Fob Programming Instructions

Call 888-934-0219 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.
Description

Follow these free keyless entry remote key fob programming instructions for 2008 Chevrolet TrailBlazer.


1. Close all doors

2. Insert key into ignition

3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down until instructed to release in step 9.

4. Perform steps 5 through 8 in a fairly rapid succession.

5. Turn the ignition to the ON position (as far as you can go without starting the engine.)

6. Turn the ignition to the OFF position.

7. Turn the ignition to the ON position (as far as you can go without starting the engine.)

8. Turn the ignition to the OFF position.

9. Release the power UNLOCK button on the door panel. The vehicle should respond by door locks locking and unlocking automatically. (If locks do not cycle after you let go, not before you let go of the unlock button, then the vehicle has not entered programming mode and you must start procedure over. Remove key from ignition, open drivers door  and return to step 1 ). If the locks do cycle automatically then proceed to step 10.

10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and unlock. This may take up to 30 seconds.

11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).

12. Turn the ignition to the ON position to exit the programming mode.

13. Test remote(s).

If you need an Automotive Locksmith to program this remote or for any other Automotive Locksmith needs please call Toll Free 855-899-6729 to find one in your area.  

      Disclaimer


   Can I Program an ignition key for this vehicle?
      Click Here ProgramAutoKeys.com 

Video

Call 844-842-7357 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.