1994 Chrysler LHS Keyless Entry Remote Fob Programming Instructions

Description

1994 Chrysler LHS Keyless Entry Remote Fob Programming Instructions 

Method-1

97 service manual says to:
1 find data kink connector under steering column.
2 turn ignition on
3 ground pin 1 upper left most pin this is the programming line.
the door locks will lock then unlock.
4 press any key on the transmitter, locks will cycle to confirm
if you have a second transmitter press any button, wait for lock to cycle.
5 remove ground from pin 1
6 Done, test it out
By the way replacement transmitter battery is a CR 2016 Radio Shack has them.

Method-2

Remove the bezel to the right of the steering wheel that has an a/c vent and the traction control switch (or not) and unplug (or find) the traction control connector. Place a jumper between pins 1 and 4 to place the receiver in teach mode. Operate the power door lock button on the door and push the lock/unlock button on the fob. If you have 2 fobs, do the 2nd one as well, it will remember 2. Replace the connector and bezel.


 
Call 855-530-0617 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.
 
 
Our free programming instruction disclaimer can be found on the ProgramYourRemote disclaimer page.