1997 Buick LeSabre Keyless Entry Remote Fob Smart Key Programming Instructions

Call 877-675-1507 for a local Locksmith
Instructions

How to Program a 1997 Buick LeSabre Keyless Entry Remote Fob Smart Key

Step by Step How to Program Instructions:
 
1. Insert key in ignition and leave in the OFF position.
 
2.  Locate the Data Link Port. It is located under dash drivers side. Be sure you know which pins are 8 and 4.

(Note port is wider at top) Your OBDII port will not have numbers, use this diagram for reference.
  
                  

3. Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a suitable jumper wire (leave connected throughout the programming procedure). Make sure you know which terminals are 8 and 4. The vehicle with respond by locking and unlocking the doors to signify entering of programming mode.
 
4. Close doors.

 

5. Turn ignition to the ON position (as far as you can go without cranking the engine). Doors will lock.
 
6. Press and hold both the LOCK and UNLOCK buttons together on the first remote to be programmed. After about 15 seconds, the vehicle will respong by locking and unlocking doors. Release the buttons on remote.
 
7. Within one minute, repeat previous step on the remaining remotes to be programmed.
 
8. Remove jumper wire applied to the OBDII Port.


     

Can I Program an ignition key? ProgramAutoKeys.com 

Video