1998 Chevrolet Suburban Keyless Entry Remote Key Fob Programming Instructions

Instructions
How to Program a 1998 Chevrolet Suburban Keyless Entry Remote Fob Smart Key

Step by Step How to Programming Instructions:

1. Locate the Data Link Port. It is located under dash drivers side. Be sure you know which pins are 8 and 4.

 
 
2. Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a suitable jumper wire (leave the jumper wire connected throughout the programming procedure). Make sure you know which terminals are 8 and 4. The vehicle will respond by locking and unlocking the doors to signify entering of programming mode.
 

3. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. After about 15 seconds, the vehicle will respond by locking and unlocking the doors. Release the buttons on the transmitter.

4. Within one minute, repeat the previous step on the remaining transmitters to be programmed.

5. Remove jumper wire applied to the OBDII Port.

 
Video
 
Call (877) 675-1507 to find a Locksmith in your area.