1998 Pontiac Grand Am Keyless Entry Remote Fob Smart Key Programming Instructions

Call 877-675-1507 for a local Locksmith


How to Program a 1998 Pontiac Grand Am Keyless Entry Remote Fob Smart Key
Step by Step How to Programming Instructions:


1. Make sure ignition is in the OFF position.

2. Locate the programming connector in the trunk (drivers side). It is a plastic connector with two wires leading up to it. The connector is not plugged into anything. You may have to pull back trim to access connector.

3. The programming connector should have two terminals. Connect both terminals with a suitable jumper wire. Make sure the terminals remain connected throughout the programming procedure.

4. Press the LOCK and UNLOCK buttons on the remote simultaneously. In response  the Keyless Entry Module will cycle all the Door Lock Motors at once. Your new  remote has been accepted and all existing remotes have been erased.

5. Repeat the previous step for each additional remotes (including any existing remotes) Do not remove jumper wire in between programming of remotes.

6. Remove the jumper wire from the Keyless Remote Connector.