2000 Honda Odyssey Keyless Entry Remote Fob Smart Key Programming Instructions

Description

2000 Honda Odyssey Keyless Entry Remote Fob Smart Key Programming Instructions

2000 EX Model with Factory Installed Keyless Entry System.
2000 EX Model with Dealer Installed Keyless Entry System.
 
 Note:
 This system will accept up to three remotes. The remotes are stored in a
 stacking-type memory. If a fourth remote is programmed  the first remote
 will be erased.

 1. Turn ignition switch to ON (II)

 2. Within 4 seconds  press the LOCK or UNOCK button on one of the remotes.
     Make sure remote is aimed at the reciever near the glove box.

 3. Within 4 seconds turn ignition switch to LOCK (0)

 4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used
     in step 2

 5. Within 4 seconds turn the ignition switch to ON (II)

 6. Within 4 seconds press the LOCK or UNLOCK button the same remote.  Make
     sure the power doorlocks cycle to confirm you are in programming mode.
     Presss the LOCK or UNLOCK buton again.

 7. Press the LOCK or UNLOCK button on each remote you want to program. Make
     sure door locks cycle after you push each remote button to confirm system has
     accepted the remote.

  8. Turn the igniton switch to LOCK (0) to exit programming mode.

  9. Test remote(s)

     


 2000 LX Model with Dealer Installed Keyless Entry System.

1. Turn ignition switch to ON (II)

 2. Press the LOCK or UNOCK button on one of the remotes. (An unprogrammed 
     remote can be used for this step.)

 3. Turn ignition switch to LOCK (0)

 4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used
     in step 2

 5. Turn the ignition switch to ON (II)

 6. Press the LOCK or UNLOCK button the same remote.  Make sure the power door
     locks cycle to confirm you are in programming mode.

 7. Press the LOCK or UNLOCK button on each remote you want to program. Make
     sure door locks cycle after you push each remote button to confirm system has
     accepted the remote.

  8. Turn the igniton switch to LOCK (0) to exit programming mode.

  9. Test remote(s)

     

Call 855-530-0617 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.
 
 
Our free programming instruction disclaimer can be found on the ProgramYourRemote disclaimer page.