2004 Nissan Frontier Keyless Entry Remote Fob Programming Instructions

Call 877-675-1507 for a local Locksmith
Instructions
How to Program a 2004 Nissan Frontier Keyless Entry Remote Fob
 
Step by Step How to Programming Instructions:
 
IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again. 
 

1.   Close and lock all doors with the driver’s side power lock/unlock switch.
 
2.   Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast, system will not enter programming mode.

3.   Insert key into the ignition cylinder and turn to the ACC position.

4.   Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.

5.   If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each transmitter (including any existing transmitters).

6. Turn the key to the OFF position then remove keys from the ignition.  Unlock the doors using the driver's side power unlock/lock switch and open the drivers side door.
 
Even if your original key and remote were separate, you can upgrade to a key with built-in remote buttons.
 
2012 Nissan Cube Remote Key Fob
 
If you have one working key Click Here to Buy Key and Programmer.
Video