2006 Dodge Dakota Keyless Entry Remote Fob Smart Key Programming Instructions


2006 Dodge Dakota Keyless Entry Remote Fob Smart Key Programming Instructions 

Use procedure #1 for Remote/Key WITHOUT transponder.

Use procedure #2 for Remote/Key WITH transponder.

Procedure #1 Remote/Key without Transponder.

NOTE: Any existing remote/keys not used during programming will no longer work. With this procedure you are only programming the remote portion of the key.

1. Enter vehicle, close all doors. Turn ignition to run position (as far as you can go without starting engine).

2. Using any PROGRAMMED  remote/key, press the UNLOCK button for 4 to 10 seconds.

3. Within the specified 4 to 10 seconds, continue pressing the UNLOCK button and press the PANIC button. A chime will sound indicating programming mode. Release both buttons.

4. Within 60 seconds carry out the following procedure for each remaining remote/keys. Press the LOCK and UNLOCK button at the same time for 2 seconds and release on a UN-PROGRAMMED remote/key. A chime will sound. Within 4 seconds press and release the UNLOCK button. A chime will sound.

5. Turn ignition to OFF and remove key. 

6. Test 

 Procedure #2 Remote/Key with Transponder

**This procedure CAN ONLY be used on vehicles built in USA.

**You MUST HAVE two working programmed Remote/keys before you can add  a third remote/key.

**If you only have ONE WORKING REMOTE/KEY and want to add a second key this procedure WILL NOT WORK.

1.  Using first programmed remote/key turn ignition to the ON position for 5 seconds. (Do not crank engine). Turn remote/key off and remove.

2.  Within 5 seconds insert second working programmed remote/key.Turn ignition to the ON position (Do not crank engine) security light will begin to flash and chime will be heard within 10 seconds. Turn remote/key off and remove. NOTE: Some vehicles will not chime, only the security light will flash.

3.  Within 5 seconds insert third NEW CUT remote/key and turn ignition to the ON  position (Do not crank engine). The security light should start flashing and within 10 seconds you should hear a chime and the security light should go out. Once the security light goes out, the new remote/key should be programmed. Turn remote/key to the OFF position, remove key.

4.  Test key and remote.


Call (877) 675-1507 to find a Locksmith in your area.