2006 Ford Fusion Keyless Entry Remote Fob Smart Key Programming Instructions

Call (877) 782-5192 for a local Locksmith
Instructions
How to Program a 2006 Ford Fusion Keyless Entry Remote Fob Smart Key
 
Step by Step How to Program Instructions:
 
Use these instructions if you have a Key or Remotehead Key system 
 
To add a new key to the system two previously programmed keys are required to add a third key. If two are not available, you will need to contact a local locksmith to program a key or Click Here to Buy a Programmer if you have one working key.

1. Insert the first previously programmed key into the ignition.

2. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.

3. Switch the ignition off and remove the first programmed key from the ignition.

4. After three seconds but within 10 seconds of switching the ignition off, insert the second previously programmed key into the ignition.

5. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.

6. Switch the ignition off and remove the second previously programmed key from the ignition.

7. After three seconds but within 10 seconds of switching the ignition off and removing the previously programmed key, insert the new unprogrammed key into the ignition.

8. Switch the ignition from off to on. Keep the ignition on for at least six seconds.

9. Remove the newly programmed key from the ignition. If the key has been successfully
programmed it will start the engine and operate the remote entry system (if the new key is an integrated keyhead transmitter). If it was not programmed successfully, wait 10 seconds and repeat Steps 1 through 8. 
to find a Locksmith in your area.