2007 Chevrolet Monte Carlo Keyless Entry Remote Key Fob Programming Instructions

Call 877-675-1507 for a local Locksmith
Instructions
How to Program a 2007 Chevrolet Monte Carlo Keyless Entry Remote Fob Smart Key

Step by Step How to Programming Instructions:

 

Use this Procedure for Vehicles with Driver Information Center Buttons

1. Insert Key and turn to ON position so you can access Driver Information Center


2. Press the vehicle information button until  PRESS TO RELEARN REMOTE KEY displays 

3. Press the set/reset button until  REMOTE KEY LEARNING ACTIVE  displays

4. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.


5. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed.

6.  To exit programming mode turn key off and remove key. Test remote(s).
 


Use this Procedure for Vehicles without Drivers Information Center Buttons

To access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking engine). 

1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays. 
 

2. Press and hold the trip odometer reset stem for three seconds. The message  REMOTE KEY LEARNING ACTIVE will display.

3. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.
 

4. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed.

5. To exit programming mode turn key off and remove key. Test remote(s).

 
Can I Program an ignition key for this vehicle? Click Here ProgramAutoKeys.com