2007 Mitsubishi Raider Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions
2007 Mitsubishi Raider Keyless Entry Remote Fob Smart Key Programming Instructions
 
Use these instructions to program the key and remote for a transponder equipped Raider 
 

You must have two working programmed keys to use this procedure.

1. Insert first programmed key into the ignition and turn ignition switch to ON. Wait for approximately 3 seconds then turn ignition to OFF and remove key.


2. Within 15 seconds of removing first key insert second programmed key into ignition and turn ignition switch to ON. Wait approximately 10 seconds. You will see the immobilizer warning lamp illuminate on the dash and you will hear an audible tone.Turn ignition OFF and remove the key.

3. Within 50 seconds insert the new unprogrammed key into ignition. Turn ignition switch to ON. After approximately 10 seconds you should hear an audible tone and the immobilizer lamp will remain illuminated for 3 seconds. Once this occurs programming is completed.

4. For each additional key you must repeat these steps starting with step number 1.

 

Use these instructions to program the remote for a non transponder equipped Raider  
 

This programming procedure requires you to already have at least 1 working original remote transmitter. (All buttons must be functional). If you do not have any remote transmitters you must get the new one programmed by a locksmith.

Obtain all remote transmitters for this vehicle. Any existing keys/remote transmitters not used during programming will become inoperative so make sure to reprogram them during procedure describe below. Sit in vehicle with all doors closed and the driver’s seat-belt on. Make sure no one else is in the vehicle.

1. Put key in ignition and turn ignition switch to ON position (as far as you can turn key without cranking engine).

2. Using a programmed key/remote transmitter perform the following:

  • Press and hold UNLOCK button.
  • After holding the UNLOCK button for a at least 4 seconds, continue holding the UNLOCK button and also press PANIC button within 6 seconds.
  • Ensure acoustic signal is emitted indicating programming mode active.
  • Release both buttons.

3. Within 60 seconds carry out the following procedure for each remaining key/remote transmitter:

  • On the unprogrammed remote, press both the LOCK and UNLOCK button at the same time for 2 seconds then release both buttons.
  • Ensure acoustic signal is emitted
  • Within 4 seconds press and release the UNLOCK button.
  • Ensure acoustic signal is emitted

4. Repeat step 3 now for each remaining key/remote transmitters including working remotes.

5. Switch ignition to OFF position or wait 60 seconds to exit programming mode.

6. Programming is now complete. Test all remotes to ensure proper programming.

Please note: a maximum 6 key remote transmitters can be programmed

 
Call (877) 675-1507 to find a Locksmith in your area.