2007 Toyota Avalon Keyless Entry Remote Fob Smart Key Programming Instructions

Call (877) 782-5192 for a local Locksmith
Instructions
How to Program a 2007 Toyota Avalon Keyless Entry Remote Fob Smart Key
 
Step by Step How to Programming Instructions:
 
The following procedure is for 2007 Avalon models that have a separate key and remote. 
 
If you have a Smart Key here are your options.
 
1. Locate an automotive locksmith in your area by visiting LocateALocksmith.com or calling 877-789-9963

2. If your Avalon has push button start Click Here to Rent Specialized Equipment 
 
 2009 Toyota Avalon Smart Keyless Entry Remote - Aftermarket
 
The following procedure is for Avalons that have a separate key and remote. This procedure is for the remote only.
  

1. Start with the key out of the ignition, drivers door is open all others closed and drivers door is unlocked.

2. Perform these steps within 5 seconds.
    A. Insert the key into the ignition(Do NOT Turn) Pull key out.
    B. Insert the key into the ignition(Do NOT Turn) Pull key out.

3. Perform these steps within 40 seconds.
    A. Close then open the drivers door.
    B. Close then open the drivers door.
    C. Insert the key into the ignition(Do NOT Turn) Pull key out.

4. Perform these steps within 40 seconds.
    A. Close then open the drivers door.
    B. Close then open the drivers door.
    C. Insert the key into ignition and leave it in ignition.
    D. Close the drivers door.
    E. Turn the ignition to ON (Do NOT Start) then back to OFF.
    F. Remove the key from the ignition.

5. Within 3 seconds, the power door locks should lock then unlock automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.

6. Perform these steps within 40 seconds.
    A. Press the lock and unlock buttons on the remote simultaneously for 1.5 seconds.
    B. Immediately after letting go of the lock and unlock buttons, Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should lock and then unlock once indicating successful programming. If the door locks cycle twice, repeat steps A and B in step 6 as the remote was not accepted.
    C. Repeat steps A and B in step 6 for each new remote.

7. Open drivers door.

Video
to find a Locksmith in your area.