2009 Honda S2000 Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions

2009 Honda S2000 Keyless Entry Remote Fob Smart Key Programming Instructions

 Dealer Installed System.
 Note:
 Entering the programming mode cancels all learned keyless remotes, so none
 of the previously programmed remotes will work.  You must reprogram all of the
 keyless remotes once you are in the programming mode.

 You must complete each step within 5 seconds  of the previous step to keep the
 system from exiting  the programming mode.

 1. Turn ignition switch to ON (II)

 2. Press the LOCK or UNLOCK button on one of the remotes. (An unprogrammed remote can be used for this step.)

 3. Turn ignition switch to LOCK (0)

 4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used in step 2

 5. Turn the ignition switch to ON (II)

 6. Press the LOCK or UNLOCK button the same remote.  Make sure the power door locks cycle to confirm you are in programming mode.

 7. Press the LOCK or UNLOCK button on each remote you want to program. Make sure door locks cycle after you push each remote button to confirm system has accepted the remote.

  8. Turn the ignition switch to LOCK (0) to exit programming mode.

  9. Test remote(s)   


 Factory Installed System

 Note:
 This system will accept up to three remotes. The remotes are stored in a stacking-type memory. If a fourth remote is programmed  the first remote will be erased.

 1. Turn ignition switch to ON (II)

 2. Within 4 seconds  press the LOCK or UNLOCK button on one of the remotes. Make sure remote is aimed at the receiver near the glove box.

 3. Within 4 seconds turn ignition switch to LOCK (0)

 4. Repeat steps 1, 2 and 3 two more times using the same keyless remote used in step 2

 5. Within 4 seconds turn the ignition switch to ON (II)

 6. Within 4 seconds press the LOCK or UNLOCK button the same remote.  Make sure the power door locks cycle to confirm you are in programming mode. Press the LOCK or UNLOCK button again.

 7. Press the LOCK or UNLOCK button on each remote you want to program. Make sure door locks cycle after you push each remote button to confirm system has accepted the remote.

  8. Turn the ignition switch to LOCK (0) to exit programming mode.

  9. Test remote(s)

  

 
Call (877) 675-1507 to find a Locksmith in your area.