2009 Subaru Impreza Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions
How to Program a 2009 Subaru Impreza Keyless Entry Remote Fob Smart Key

Step by Step How to Programming Instructions:
 
Programming the remote (from the owners manual) Please read through this first since everything needs to be done in a quick sequence
 
1. Sit in the driver's seat, close all doors and the rear gate or trunk lid etc
 
2. Open and close the driver's door one time,
 
    Within 45 seconds
3. Open and close the driver's door once
 
4. Turn the ignition key from LOCK to ON 10 times within 15 seconds. An electronic tone will sound once, a buzzer will continue to sound and the interior light will continue to flash until the transmitter codes are completely registered.
 
If you do not perform the steps within 45 seconds an error will occur and neither an electronic tone nor the buzzer will sound and the interior lamp will not flash. In this event, start all over again.
 
Within 45 seconds do the following.
Open and close the driver's door once within 15 seconds and an electronic tone will sound for 30 seconds. If you do not perform the operations within 15 seconds an error will occur and the electronic tone will not sound. In this event, perform the registration steps again beginning with # 3 above.
 
Before the electronic tone stops, press the power door lock button to LOCK the same number of times as the leftmost digit of the transmitter code. For example, press the LOCK button 8 times if the leftmost digit of the code is 8. If the number is 3 then LOCK the door 3 times etc... When you have finished entering the number, push to UNLOCK side within five seconds and Then do that for all the remaining 7 digits of the code. After each series pull the lock knob to the UNLOCK side within five seconds. When you are finished, within 5 seconds push that LOCK button to UNLOCK one time and then do it all again, the full series.
 
Yes, once again start with the left digit and re-enter each one using the lock button within a few seconds. When you have entered the eighth digit the second time an electronic tone will sound for 30 seconds. The electronic tone will stop sounding when you start entering the number.
 
If you do not start entering the number using the lock knob before the electronic tone stops sounding, an error will occur. In this event, perform the registration steps again beginning with part 3 above. If the interval between one push of the knob and the next exceeds five seconds, an error will occur. In this event, perform the procedure again beginning with part 4. If an error occurs six times, perform the procedure again starting with part 3. If the code entered the second time is not identical to the code entered the first time, an error will occur. In this event, perform the procedure again beginning with part 5. If an error occurs five times, perform the procedure again starting with part 3.
 
If you wish to program another transmitter code into the system (up to four transmitter codes can be programmed into the system), perform the procedure beginning with part 4. When you have finished programming all of the necessary transmitter codes into the system, remove the key from the ignition switch. Test Remotes
 
 
 
Call (877) 675-1507 to find a Locksmith in your area.