2010 GMC Sierra Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions

How to Program a 2010 GMC Sierra Keyless Entry Remote Fob Smart Key

Step by Step How to Program Instructions:
 
Use this Procedure for Vehicles with Driver Information Center Buttons

1. Insert Key and turn to ON position so you can access Driver Information Center

2. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays 

3. Press the set/reset button until REMOTE KEY LEARNING ACTIVE  displays

4. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.

5. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed.

6. To exit programming mode turn key off and remove key.  Test remote(s).
 
 
Step by Step How to Program Instructions:


Use this Procedure for Vehicles without Drivers Information Center Buttons

To access this display, the vehicle must be in Park (P) with key in the on position (as far as you can go without cranking engine.

1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays. 

2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE  will display

 
3.  Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed.
 

4.  To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed.

5. To exit programming mode turn key off and remove key. Test remote(s)

   Can I Program an ignition key for this vehicle?
      Click Here ProgramAutoKeys.com 

 
Video
 
Call (877) 675-1507 to find a Locksmith in your area.