2010 Jeep Wrangler Keyless Entry Remote Fob Smart Key Programming Instructions

Description
2010 Jeep Wrangler Keyless Entry Remote Fob Smart Key Programming Instructions
 

Note: You must have two valid keys to add a new key to the system.

1. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON/RUN position for at least three seconds, but no longer than 15 seconds. Then, Turn the ignition switch to the LOCK position and remove the first key.

2. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON/RUN position within 15 seconds. After 10 seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash. Turn the ignition switch to the LOCK position and remove the second key.

3. Insert the new key into the ignition switch. Turn the ignition switch  to the ON/RUN position.within 60 seconds. After 10 seconds, a single chime will sound. In addition, the Vehicle Security Light will stop flashing. To indicate that programming is complete, the Vehicle Security Light will turn on again for seconds and then turn off.

The new key is now programmed. The Remote Keyless Entry transmitter will also be programmed during this procedure.

Repeat this procedure to program up to eight keys. 

 

Note: If you do not have 2 valid working keys you will have to call a Locksmith to program or originate a key for you.

 

Call 855-530-0617 to find a Locksmith in your area to program this remote or go to LocateALocksmith.com to find one in your area.
 
 
Our free programming instruction disclaimer can be found on the ProgramYourRemote disclaimer page.