2011 Ford F150 Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions
How to Program a 2011 Ford F150 Keyless Entry Remote Fob Smart Key
 
Step by Step How to Program Instructions:
 
A maximum of eight keys can be programmed to your vehicle. Only SecuriLock keys can be used. To program a key yourself, you will need two previously programmed keys (keys that already operate your vehicle’s engine) and the new unprogrammed key(s) readily accessible for timely implementation of each step in the procedure.

Please read and understand the entire procedure before you begin.

1. Insert the first previously programmed key into the ignition and turn the ignition from the OFF position to the ON position (maintain ignition in the ON position for at least one
second, but no more than 10 seconds).

2. Turn ignition from the ON position back to the OFF position in order to remove the first programmed key from the ignition.

3. After three seconds but within 10 seconds of removing the first  previously programmed key, insert the second previously programmed key into the ignition and turn the ignition from the OFF  position to the ON position (maintain ignition in the ON position for at least one second but no more than 10 seconds).

4. Turn the ignition from the ON position back to the OFF position in order to remove the second programmed key from the ignition.

5. After three seconds but within 10 seconds of removing the second programmed key, insert the new unprogrammed key (new key/valet key) into the ignition and turn the ignition from the OFF position to the ON position (maintain ignition in the ON position for at least one second, but no more than 10 seconds). This step will program your new key to a programmed key.

6. To program additional new unprogrammed key(s), repeat Steps 1 through 5.

If successful, the new programmed key(s) will start the vehicle’s engine and operate the remote portion of the key.
 
 
If the remote portion of your remote head key did not program with the above procedure use the following procedure to program the remote portion.  
1. DO NOT depress brake pedal during this programming procedure.
 
2. Unlock all doors using the power door lock switch on door panel.  
 

3. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode.

4. Within 20 seconds press any button on first keyless remote. Door locks will cycle to confirm programming.

5. Within 20 seconds, press any button on second keyless remote. Door locks will cycle again to confirm programming.

6. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.

 
Call (877) 675-1507 for a Locksmith in your area.