2011 Jeep Liberty Keyless Entry Remote Fob Smart Key Programming Instructions

Call 877-675-1507 for a local Locksmith
Instructions
How to Program a 2011 Jeep Liberty Keyless Entry Remote Fob Smart Key
  
Step by Step How to Programming Instructions:
 
Note: You must have two programmed keys to add a new key to the system. 
 

1. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON/RUN position for at least three seconds, but no longer than 15 seconds. Then, Turn the ignition switch to the LOCK position and remove the first key.

2. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON/RUN position within 15 seconds. After 10 seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash. Turn the ignition switch to the LOCK position and remove the second key.

3. Insert the new key into the ignition switch. Turn the ignition switch to the ON/RUN position. within 60 seconds. After 10 seconds, a single chime will sound. In addition, the Vehicle Security Light will stop flashing. To indicate that programming is complete, the  Vehicle Security Light will turn on again for seconds and then turn off.

The new key is now programmed.

The Remote Keyless Entry transmitter will also be programmed during this procedure.

Repeat this procedure to program up to eight keys. 

 
**If you only have ONE WORKING REMOTE/KEY and want to add a second key, Click Here to Buy Programmer. 
 
**If you have no working keys. Click Here to Locate A Locksmith in your area.