How to Program a 2012 Buick Verano Keyless Entry Remote Fob Smart Key
Step by Step How to Programming Instructions:
If you have a flip key or key and you have lost all keys you will need to locate a locksmith to program a key.
1. Locate an automotive locksmith in your area using the phone number or website below.
2. If your vehicle is still mobile, it may save you money by driving to the locksmith instead of having them come to you.
3. The locksmith will then hook up specialized computer equipment to your vehicle in order to program the smart key remote fob.
If you have one programmed flip key or key and you want to add a key to the system use the following instructions
1. Insert the original, already programmed key in the ignition and turn to the key to the ON/RUN position.
2. Turn the key to LOCK/OFF, and remove the key.
3. Insert the new key to be programmed and turn it to the ON/RUN position within five seconds. The security light will turn off once the key has been programmed.
4. Repeat Steps 1 thru 3 if additional keys are to be programmed Programming with a Recognized Transmitter To program a new key.
If you have a smart key and you have lost all keys use the following instructions. (Keyless Access Vehicles Only)
1. Insert the key of the transmitter into the door lock cylinder and cycle to the unlock position 5 times within 10 seconds. The Driver's Information Center (DIC) reads "Remote Learn Pending. Please Wait."
2. Wait for 10 minutes until the DIC reads " Press Engine Start Button Learn", and then press the ignition button. The DIC will again read "Remote Learn Pending. Please Wait."
3. Repeat step 2 twice. After the 3rd time, all previously working transmitters will no longer work and DIC will show "Ready For Remote #1."
4. Place the transmitter in the transmitter pocket. The transmitter pocket is located inside the center console, under the cupholder. The cupholder has to be pulled out to access the transmitter pocket.
5. Press the ignition button. When the transmitter is accepted, the DIC will show "Ready For Remote #2."
6. Remove the transmitter from the pocket, and press the unlock button.
7. Repeat steps 4-6 to add additional transmitters. When done, press, and hold the ignition button for 5 seconds to exit programming mode.
If you have one programmed smart key and you want to add another smart key use the following instructions. (Keyless Access Vehicles Only)
1. Place the original transmitter in the cupholder.
2. Insert the key of the new transmitter into the door and cycle to unlock position 5 times within 10 seconds. The Driver's Information Center (DIC) reads Ready For Remote #2, 3, 4 or 5.
3. Place the new transmitter in the transmitter pocket. The transmitter pocket is located inside the center console, under the cupholder. The cupholder has to be pulled out to access the transmitter pocket.
4. Press the ignition button. When the transmitter is learned, the DIC will show "Ready For Remote # (next transmitter)."
5. Remove the transmitter from the transmitter pocket, and press the unlock button.
6. Repeat steps 3 to 5 to add additional transmitters. When done, press, and hold the ignition button for 5 seconds to exit programming mode.