2015 Ford Edge Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions
How to Program a 2015 Ford Edge Keyless Entry Remote Fob Smart Key
 
Step by Step How to Program Instructions:
 
Use these instructions if your Ford Edge has the remote head key system.
You must have two previously programmed keys and the new unprogrammed key readily accessible. If you do not have two previously programmed keys you will need a Locksmith to cut and program a second key.

1. Insert the first previously programmed key into the ignition.

2. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.

3. Switch the ignition off and remove the first programmed key from the ignition.

4. After three seconds but within 10 seconds of switching the ignition off, insert the second previously programmed key into the ignition.

5. Switch the ignition from off to on. Keep the ignition on for at least three seconds, but no more than 10 seconds.

6. Switch the ignition off and remove the second previously programmed key from the ignition.

7. After three seconds but within 10 seconds of switching the ignition off and removing the previously programmed key, insert the new unprogrammed key into the ignition.

8. Switch the ignition from off to on. Keep the ignition on for at least six seconds.

9. Remove the newly programmed key from the ignition. If the key has been successfully
programmed it will start the engine and operate the remote entry system (if the new key is an integrated keyhead transmitter). If it was not programmed successfully, wait 10 seconds and repeat Steps 1 through 8.
 

 
Step by Step How to Program Instructions:
 
Use these instructions if your Ford Edge has the smart key system.
You must have two previously programmed smart keys inside the vehicle and the new unprogrammed smart key readily accessible.
 
Note: A maximum of four smart keys can be programmed to your vehicle. If you would like to replace a previously programmed smart key with a new smart key, or if you already have four smart keys programmed to your vehicle, you must contact a Locksmith to be erased and reprogrammed.

Ensure that the vehicle is off before beginning this procedure. Ensure that all doors are closed before beginning this procedure and that all doors remain closed throughout the procedure. Perform this procedure exactly as described below, and perform all steps within 30 seconds of starting the sequence. If any steps are performed out of sequence, stop and wait for at least one minute before starting again. Please read and understand the entire procedure before you begin.
 
1.Open the floor console storage compartment lid. With the buttons facing the rear of your vehicle and the key ring up, place the intelligent access key into the backup slot

2. With the buttons facing the rear of your vehicle and the key ring up, place the smart key into the backup slot

3. Press the push button ignition switch.

4. Wait five seconds and then press the push button ignition switch again.

5. Remove the smart key.

6. Within 10 seconds, place a second programmed smart key in the backup slot and press the push button ignition switch.
 
7. Wait five seconds and then press the push button ignition switch again.

8. Remove the smart key.
 
9. Wait five seconds, then place the unprogrammed smart key in the backup slot and press the push button ignition switch.
 
Programming is now complete. Check that the remote control functions operate and your vehicle starts with the new smart key. If programming was unsuccessful, wait 10 seconds and repeat Steps 1 through 7. 
 
 
Call (877) 675-1507 to find a Locksmith in your area.