2016 Chevrolet Volt Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions
How to Program a 2016 Chevrolet Volt Keyless Entry Remote Fob Smart Key
 
Step by Step How to Programming Instructions:
 
Programming with a Recognized Transmitter
A new transmitter can be programmed to the vehicle when there is one recognized transmitter. To program, the vehicle must be off and all of the transmitters, both currently recognized and new, must be in the vehicle.
 
1. Place the recognized transmitter(s) in the cupholder.
 
2. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key of the new transmitter into the key lock cylinder on the outside of the driver door and turn the key counterclockwise to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays READY FOR REMOTE #2, 3, 4 OR 5 etc.
3. Remove the rubber mat in the center console storage area.
 
4. Place the new RKE transmitter into the transmitter pocket.
 
5. Press and hold POWER O on the center stack for two seconds. When the transmitter is programmed, the DIC will show that it is ready to program the next transmitter.
 
6. Remove the transmitter from the transmitter pocket and press unlock or lock on the transmitter. To program additional transmitters, repeat Steps 4–6. When all additional transmitters are programmed, press and hold POWER O for 12 seconds to exit programming mode.
 
7. Return the key back into the transmitter.
 
 
Step by Step How to Programming Instructions:
 
Programming without a Recognized Transmitter
Program a new key to the vehicle when a recognized key is not available. Follow this procedure to program up to eight transmitters. Canadian regulations require that owners see their dealer. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all transmitters to be programmed must be with you.
 
1. Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key of the transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays REMOTE LEARN PENDING, PLEASE WAIT.
 
2. Wait for 10 minutes until the DIC displays PRESS START BUTTON TO LEARN and then press POWER O on the center stack. The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.
 
3. Repeat Step 2 two more times. After the third time, all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be programmed during the next steps. The DIC display should now show READY FOR REMOTE #1.
 
4. Remove the rubber mat in the center console storage area.
 
5. Place the new transmitter into the transmitter pocket.
 
6. Press and hold POWER O for two seconds. When the transmitter is programmed, the DIC will show that it is ready to program the next transmitter.
 
7. Remove the transmitter from the transmitter pocket and press unlock on the transmitter.
 
To program additional transmitters, repeat Steps 5–7.When all additional transmitters are programmed, press and hold POWER O for 12 seconds to exit programming mode.

8. Return the key back into the transmitter.
 
 
 
Call (877) 675-1507 to find a Locksmith in your area.