2017 GMC Yukon Denali Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions

How to Program a 2017 GMC Yukon Denali Keyless Entry Remote Fob Smart Key 

 
Step by Step How to Program Instructions: 
 
Use these instructions if your Yukon has a separate key and remote.  
There is no manual on board procedure to program a keyless remote to this vehicle. This vehicle requires special equipment be connected to the vehicle to program the remote.

 

 
 
Use these instructions if your Yukon has one programmed Smart Key.
A new fob can be programmed to the vehicle when there is one programmed remote. To program, the vehicle must be off and all remotes, both currently programmed and new, must be with you.

1. Remove the key from the key from the programmed remote.

2. Place the programmed remote in the cupholder or passenger seat.

3. Insert the vehicle key into the key lock cylinder on the driver door handle. Then turn the key counterclockwise, to the unlock position, five times within 10 seconds. The Driver Information Center (DIC) displays READY FOR REMOTE #2, 3, 4, ETC.

4. Place the new remote in the remote pocket/insert. Open the center console storage area and the storage tray. The remote pocket/insert is in front of the storage area next to the center console storage area between the driver and front passenger seats.

5. Press the ENGINE START/STOP button. When the remote is learned, the DIC display will show that it is ready to program the next remote.

6. Remove the remote from the remote pocket and press unlock or lock on the remote. To program additional remotes, repeat Steps 4–6. When all additional remotes are programmed, press and hold the ENGINE START/STOP button for approximately 12 seconds to exit programming mode.

7. Return the key back into the remote.
 
 


Step by Step How to Program Instructions: 
 
Use these instructions for Programming without a programmed Smart Key
If there are no currently programmed remotes available, follow this procedure to program up to eight remotes. This feature is not available in Canada. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all remotes to be programmed must be with you.

1. Remove the vehicle key from the remote.

2. Insert the vehicle key into the key lock cylinder on the driver door handle; then turn the key counterclockwise, to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays REMOTE LEARN PENDING, PLEASE WAIT.
 
 3. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN,
then press the ENGINE START/ STOP button. The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.

4. Repeat Step 3 two additional times. After the third time all previously known remotes will no longer work with the vehicle. Remaining remotes can be relearned during the next steps. The DIC display should now show READY FOR REMOTE # 1.

5. Place the new remote in the remote pocket/insert. Open the center console storage area and the storage tray. The remote pocket/insert is in front of the storage area next to the center console storage area between the driver and front passenger seats.

6. Press the ENGINE START/STOP button. When the remote is learned, the DIC display will show that it is ready to program the next remote.

7. Remove the remote from the remote pocket/insert and press unlock or lock on the remote. To program additional remotes, repeat Steps 5–7. When all additional remotes are programmed, press and hold the ENGINE START/STOP button for approximately 12 seconds to exit programming mode.

8. Return the key back into the remote

 
 

 
Call (877) 675-1507 to find a Locksmith in your area.