2018 Cadillac XTS Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions
How to Program a 2018 Cadillac XTS Keyless Entry Remote Fob Smart Key 
 
Step by Step How to Programming Instructions: 
 
Programming with two Recognized Transmitters
A new transmitter can be programmed to the vehicle when there are two recognized transmitters. To program, the vehicle must be off and all transmitters, both currently recognized and new, must be with you.
 
1. Open the center console storage area and the storage tray.
 
2. Place the recognized transmitters in the pocket. The transmitter pocket is inside the center console storage area between the driver and front passenger seats.
 
3. Remove the key lock cylinder cap. Insert the vehicle key into the key lock cylinder on the driver door handle. Then turn the key counterclockwise, to the unlock position, five times within 10 seconds. The Driver Information Center (DIC) displays READY FOR REMOTE #2, 3, 4, ETC.
 
4. Replace the recognized transmitter with a new transmitter. Place the new transmitter in the transmitter pocket.
 
5. Press the ENGINE START/STOP button. When the transmitter is learned, the DIC display will show that it is ready to program the next transmitter.
 
6. Remove the transmitter from the transmitter pocket and press unlock or lock on the transmitter. To program additional transmitters, repeat Steps 4–6. When all additional  transmitters are programmed, press and hold the ENGINE START/STOP button for approximately 12 seconds to exit programming mode.
 
 
 
Programming without a Recognized Transmitter
If there are no currently recognized transmitters available, follow this procedure to program up to eight transmitters. This feature is not available in Canada. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all transmitters to be programmed must be with you.
 
1. Remove the key lock cylinder cap. Insert the vehicle key into the key lock cylinder on the driver door handle; then turn the key counterclockwise, to the unlock position five times within 10 seconds.The Driver Information Center(DIC) displays REMOTE LEARN PENDING, PLEASE WAIT.
 
2. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN, then press the ENGINE START/STOP button. The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.
 
3. Repeat Step 2 two additional times. After the third time all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC display should now show READY FOR REMOTE # 1.
 
4. Place the new transmitter in the transmitter pocket. The transmitter pocket is inside the center console storage area between the driver and front passenger seats. The storage area will need to be opened to access the transmitter pocket.
 
5. Press the ENGINE START/STOP button. When the transmitter is learned, the DIC display will show that it is ready to program the next transmitter.

6. Remove the transmitter from the transmitter pocket and press unlock or lock on the transmitter.
 
To program additional transmitters, repeat Steps 4–6. When all additional transmitters are  programmed, press and hold the ENGINE START/STOP button for approximately 12  seconds to exit programming mode.
 
 
 
Call (877) 675-1507 to find a Locksmith in your area.