2018 Chevrolet Suburban Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions
How to Program a 2018 Chevrolet Suburban Keyless Entry Remote Fob Smart Key
 
Step by Step How to Programming Instructions:
 
If your Suburban has a separate key and remote there is no manual on board procedure to program a keyless remote to this vehicle. This will require a locksmith with special equipment to be connected to the vehicle to program the remote.
 
 
Use these instructions to program if you have the Smart Key System
Programming with Recognized Transmitters (Keyless Access Vehicles Only) 
Programming with Recognized Transmitters A new transmitter can be programmed to the vehicle when there are two recognized transmitters. To program, the vehicle must be off and all transmitters, both currently recognized and new, must be with you.
 
1. Remove the key from the recognized transmitter.
 
2. Place the two recognized transmitters in the cupholder or on the passenger seat.
 
3. Insert the vehicle key into the key lock cylinder on the driver door handle. Then turn the key counterclockwise, to the unlock position, five times within 10 seconds. 
The DIC displays READY FOR REMOTE #3, 4, 5 ETC.
 
4. Place the new transmitter in the transmitter pocket/insert. Open the center console storage area and the storage tray. The transmitter pocket/ insert is in front of the storage area next to the center console storage area between the driver and front passenger seats 
 
5. Press ENGINE START/STOP. When the transmitter is learned, the DIC display will show that it is ready to program the next transmitter.
 
6. Remove the transmitter from the transmitter pocket and press Unlock or Lock on the transmitter. To program additional transmitters, repeat Steps 4–6. When all additional transmitters are programmed, press and hold ENGINE START/STOP for approximately 12 seconds to exit programming mode.
 
7. Return the key back into the transmitter 
 
Programming without Recognized Transmitters
If two currently recognized transmitters are not available, follow this procedure to program up to eight transmitters. This feature is not available in Canada. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all transmitters to be programmed must be with you.
 
1. Remove the vehicle key from the transmitter.
 
2. Insert the vehicle key into the key lock cylinder on the driver door handle; then turn the key counterclockwise, to the unlock position, five times within 10 seconds. The DIC displays REMOTE LEARN PENDING, PLEASE WAIT.
 
3. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN, then press ENGINE START/STOP. The DIC will again display REMOTE LEARN PENDING, PLEASE WAIT.
 
4. Repeat Step 3 two additional times. After the third time all previously known transmitters will no longer work with the vehicle. Remaining transmitters can be relearned during the next steps. The DIC should now display READY FOR REMOTE # 1.
 
5. Place the new transmitter in the transmitter pocket/insert. Open the center console storage area and the storage tray. The transmitter pocket/ insert is in front of the storage area next to the center console storage area between the driver and front passenger seats.
 
6. Press ENGINE START/STOP. When the transmitter is learned, the DIC display will show that it is ready to program the next transmitter.
 
7. Remove the transmitter from the transmitter pocket/insert and press Unlock or Lock on the transmitter. To program additional transmitters, repeat Steps 5–7. When all additional transmitters are programmed, press and hold ENGINE START/STOP for approximately 12 seconds to exit programming mode.
 
8. Return the key back into the transmitter  
Video
 
Call (877) 675-1507 for a Locksmith in your area.