Use these instructions when you have two Programmed Remotes.
To program, the vehicle must be off and all of the remotes, both currently programmed and new, must be with you.
1. Place the two programmed remotes in the front cupholder.
2. Remove the key lock cylinder cap on the driver door handle.
3. Insert the vehicle key of the new remote into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays READY FOR REMOTE #2, 3, 4 or 5.
4. Place the new remote into the front cupholder.
5. Press ENGINE START/STOP. When the remote is learned, the DIC will show that it is ready to program the next remote.
6. Remove the remote from the remote pocket and press unlock. To program additional remotes, repeat Steps 3–5. When all additional remotes are programmed, press and hold ENGINE START/STOP for 12 seconds to exit programming mode.
7. Put the key back into the remote.
Use these instructions without two Programmed Remotes.
If two currently programmed remotes are not available, follow this procedure to program up to eight remotes. This feature is not available in Canada. This procedure will take approximately 30 minutes to complete. The vehicle must be off and all of the remotes you wish to program must be with you.
1. Remove the key lock cylinder cap on the driver door handle.
2. Insert the vehicle key of the remote into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays REMOTE LEARN PENDING, PLEASE WAIT.
3. Wait for 10 minutes until the DIC displays PRESS ENGINE START BUTTON TO LEARN and then press ENGINE START/STOP. The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.
4. Repeat Step 2 two additional times. After the third time, all previously known remotes will no longer work with the vehicle. Remaining remotes can be relearned during the next steps. The DIC display should now show READY FOR REMOTE #1.
5. Place the new remote into the remote pocket inside the armrest storage area.
6. Press ENGINE START/STOP. When the remote is learned the DIC will show that it is ready to program the next remote.
7. Remove the remote from the remote pocket and press unlock. To program additional remotes, repeat Steps 4–6. When all additional remotes are programmed, press and hold ENGINE START/STOP button for 12 seconds to exit programming mode.
8. Put the key back into the remote.