2019 Lincoln Continental Keyless Entry Remote Fob Smart Key Programming Instructions

Instructions
How to Program a 2019 Lincoln Continental Keyless Entry Remote Fob Smart Key

Step by Step How to Program Instructions:
 
You must have two previously programmed intelligent access keys inside your vehicle and the new unprogrammed intelligent access key readily accessible. 
 
Make sure that the ignition is switched off before beginning this procedure. Make sure that you close all the doors before beginning and that they remain closed throughout the procedure. Carry out all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if you carry out any steps out of sequence. Read and understand the entire procedure before you begin.
 
1. Remove the key blade from the transmitter.  
 
2. Open the floor console storage compartment lid.
 
3. Insert the first programmed key in the backup slot.
 
4. Press the push button ignition switch.
 
5. Wait five seconds and then press the push button ignition switch again.
 
6. Remove the intelligent access key.
 
7. Within 10 seconds, place a second programmed intelligent access key in the backup slot and press the push button ignition switch.
 
8. Wait five seconds and then press the push button ignition switch again.
 
9. Remove the intelligent access key.
 
10. Wait five seconds, then place the unprogrammed intelligent access key in the backup slot and press the push button ignition switch. Programming is now complete. Check that the remote control functions operate and your vehicle starts with the new intelligent access key. If programming was unsuccessful, wait 10 seconds and repeat steps 1 through 7. 
 
 
 
Call (877) 675-1507 to find a Locksmith in your area.